Telum - Damper Units (Wholesale)

Please note that a complete Telum has 3 mandatory subcomponents:

1. Damper unit - order these on this page.
   48 SKUs to cover all options for stroke (incl 2.5mm increments) and eyelets
   OR
   12 SKUs if willing to swap bumper plates for 2.5mm stroke differences
   OR
   6 SKUs if willing to reset IFP depth to alter stroke by 5mm (eg from 65mm to 60mm), which also requires replacing the eyelet
   Damper unit selection dictates eye to eye and the reservoir-end mounting type (eyelet or trunnion). 
   
   
2. Spring (Vorsprung-branded Sprindex)
   18 SKUs - order here: https://vorsprungsuspension.com/products/telum-springs-wholesale-only
   
   
3. Reducer hardware
   Order here - https://vorsprungsuspension.com/products/telum-reducer-hardware-wholesale-1

Optional subcomponents (not required with every shock), available separately:

1. Shaft eyelet - note that complete damper units come with the specified shaft eyelet installed. 
   4 SKUs:
   1. Spherical or 15.08mm cylindrical - use these only in cases where sphericals cannot work (eg yokes or frames with 15mm lower eyelet mounts)
   2. Full stroke (short eyelet) or 5mm shortened stroke (long eyelet). 
2. 2.5mm travel reduction bumper plate (eg for 62.5mm stroke rather than 65). 
3. Cylindrical eyelet reducer for reservoir bridge (use only in the case that spherical bearings cannot be used in the reservoir bridge)
4. 5mm sealhead spacer to reduce stroke (requires IFP depth to be reset)

At least one Vorsprung-branded Sprindex spring must be ordered with each damper unit. Dampers are to be sold with Vorsprung-branded springs and Vorsprung hardware. Vorsprung hardware is required for the sphericals to work properly, otherwise the shock/eyelets may rub on the frame. Other brands' reducer hardware should not be sold with the shock.